Minute Mount 1 Wiring Diagram

Fisher Minute Mount 1 Wiring Harness Diagram and Installation Instructions

Introduction

The Fisher Minute Mount 1 wiring harness diagram illustrates the various components of the system including the wiring harness control module, solenoid valve, and reservoir. The wiring schematic provides a detailed illustration of how these components are connected. Following these instructions will ensure that the wiring diagram is installed correctly and that your Minute Mount snowplow is functioning properly.

Materials Needed

To install the Fisher Minute Mount 1 wiring harness, you will need the following materials:

• Wire stripper
• Electrical tape
• Wire connectors
• Multimeter (optional)

Installation Instructions

To install the Fisher Minute Mount 1 wiring harness, follow these steps:

1. Disconnect the negative battery terminal.
2. Locate the wiring harness control module. It is usually located near the battery.
3. Connect the black wire from the wiring harness to the negative battery terminal.
4. Connect the red wire from the wiring harness to the positive battery terminal.
5. Connect the blue wire from the wiring harness to the solenoid valve.
6. Connect the yellow wire from the wiring harness to the reservoir.
7. Test the wiring harness by connecting the multimeter to the black and red wires. The multimeter should read 12 volts.
8. Reconnect the negative battery terminal.

Conclusion

Once the wiring harness is installed, your Fisher Minute Mount snowplow should be functioning properly. If you have any questions, please consult the owner's manual or contact Fisher Customer Service.